| DOI: | 10.2172/1064408
|
| 报告号: | None
|
| 报告题名: | Pre-Combustion Carbon Capture by a Nanoporous, Superhydrophobic Membrane Contactor Process |
| 作者: | Meyer, Howard; Zhou, S James; Ding, Yong; Bikson, Ben
|
| 出版年: | 2012
|
| 发表日期: | 2012-03-31
|
| 国家: | 美国
|
| 语种: | 英语
|
| 中文主题词: | 碳
; 压差
; 吸收
; 电力
; 吸附作用
|
| 主题词: | CARBON
; DIFFERENTIAL PRESSURE
; ABSORPTION
; ELECTRICITY
|
| 英文摘要: | This report summarizes progress made during Phase I and Phase II of the project: "Pre-Combustion Carbon Capture by a Nanoporous, Superhydrophobic Membrane Contactor Process," under contract DE-FE-0000646. The objective of this project is to develop a practical and cost effective technology for CO{sub 2} separation and capture for pre-combustion coal-based gasification plants using a membrane contactor/solvent absorption process. The goals of this technology development project are to separate and capture at least 90% of the CO{sub 2} from Integrated Gasification Combined Cycle (IGCC) power plants with less than 10% increase in the cost of energy services. Unlike conventional gas separation membranes, the membrane contactor is a novel gas separation process based on the gas/liquid membrane concept. The membrane contactor is an advanced mass transfer device that operates with liquid on one side of the membrane and gas on the other. The membrane contactor can operate with pressures that are almost the same on both sides of the membrane, whereas the gas separation membranes use the differential pressure across the membrane as driving force for separation. The driving force for separation for the membrane contactor process is the chemical potential difference of CO{sub 2} in the gas phase and in the absorption liquid. This process is thus easily tailored to suit the needs for pre-combustion separation and capture of CO{sub 2}. Gas Technology Institute (GTI) and PoroGen Corporation (PGC) have developed a novel hollow fiber membrane technology that is based on chemically and thermally resistant commercial engineered polymer poly(ether ether ketone) or PEEK. The PEEK membrane material used in the membrane contactor during this technology development program is a high temperature engineered plastic that is virtually non-destructible under the operating conditions encountered in typical gas absorption applications. It can withstand contact with most of the common treating solvents. GTI and PGC have developed a nanoporous and superhydrophobic PEEK-based hollow fiber membrane contactor tailored for the membrane contactor/solvent absorption application for syngas cleanup. The membrane contactor modules were scaled up to 8-inch diameter commercial size modules. We have performing extensive laboratory and bench testing using pure gases, simulated water-gas-shifted (WGS) syngas stream, and a slipstream from a gasification derived syngas from GTI's Flex-Fuel Test Facility (FFTF) gasification plant under commercially relevant conditions. The team have also carried out an engineering and economic analysis of the membrane contactor process to evaluate the economics of this technology and its commercial potential. Our test results have shown that 90% CO{sub 2} capture can be achieved with several physical solvents such as water and chilled methanol. The rate of CO{sub 2} removal by the membrane contactor is in the range of 1.5 to 2.0 kg/m{sup 2}/hr depending on the operating pressures and temperatures and depending on the solvents used. The final economic analysis has shown that the membrane contactor process will cause the cost of electricity to increase by 21% from the base plant without CO{sub 2} capture. The goal of 10% increase in levelized cost of electricity (LCOE) from base DOE Case 1(base plant without capture) is not achieved by using the membrane contactor. However, the 21% increase in LCOE is a substantial improvement as compared with the 31.6% increase in LCOE as in DOE Case 2(state of art capture technology using 2-stages of Selexol{TM}). |
| URL: | http://www.osti.gov/scitech/servlets/purl/1064408
|
| Citation statistics: |
|
| 资源类型: | 研究报告
|
| 标识符: | http://119.78.100.158/handle/2HF3EXSE/40712
|
| Appears in Collections: | 过去全球变化的重建
影响、适应和脆弱性
科学计划与规划
气候变化与战略
全球变化的国际研究计划
气候减缓与适应
气候变化事实与影响
|
| File Name/ File Size |
Content Type |
Version |
Access |
License |
|
|---|
| 1064408.pdf（4509KB） | 研究报告 | -- | 开放获取 | | View
Download
|
|
| Recommended Citation: | |
Meyer, Howard,Zhou, S James,Ding, Yong,et al. Pre-Combustion Carbon Capture by a Nanoporous, Superhydrophobic Membrane Contactor Process. 2012-01-01.
|
|
|